![]() ![]() ![]() You must then, check the DHCP server for the correct time. If you have any experience provisioning a Polycom desk phone, then getting the Polycom IP 6000 set up will be nothing new to you. Polycom Boot Server Step 1: Locate the MAC address of your Polycom phone Step 2: Add the MAC Address of your phone in the OnSIP Admin Portal Step 3: Add boot. There is one potential issue with Polycom phones and the time settings: The DHCP server will ALWAYS over-ride the time settings from the If the above settings do not correct reset the time settings for the phone, then the phone is obtaining it's time settings from the DHCP server. Log into the IP address of the phone:Ĭhoose "Submit" to submit your settings and reboot the phone. ![]() This can be done by logging into your Polycom phone through a web browser. The OnSIP Boot Server serves the latest tested and verified firmware version and user settings for the following models. The date and time on the phone can be set by synchronizing it with an NTP server (Network Time Protocol server). This article is for historical reference only. We've made an update to our Polycom Boot Server that fixes a security issue on 'legacy' Polycom models. Your computers IP address To use your PC as the provisioning boot server. I tried scenario 1 just for a test subnet in our infra. Guide for full details on how to provision multiple Polycom phones and. Apply the vendor specific rules for DHCP and configure the Provisiong Server Name as a DHCP suboption for this vendor specific class. yesterday I was reviewing how to provision a polycom phone and ran across a page that talked about sip servers. Time and Date should be set through the Polycom Boot Server. Fill in option 66 with the Provisioning Server Name. ![]()
0 Comments
Leave a Reply. |